Mazda 3 Owners Manual: Wiper Blades

Mazda 3 Owners Manual / Maintenance and Care / Owner Maintenance / Wiper Blades

CAUTION

Hot waxes applied by automatic car washers have been known to aff ect the wiper's ability to clean windows.
To prevent damage to the wiper blades, do not use gasoline, kerosene, paint thinner, or other solvents on or near them.
When the wiper lever is in the AUTO position and the ignition is switched ON, the wipers may move automatically in the following cases:

If the windshield above the rain sensor is touched.
If the windshield above the rain sensor is wiped with a cloth.
If the windshield is struck with a hand or other object.
If the rain sensor is struck with a hand or other object from inside the vehicle.

Be careful not to pinch hands or fi ngers as it may cause injury, or damage the wipers. When washing or servicing the vehicle, make sure the wiper lever is in the OFF position.

Contamination of either the windshield or the blades with foreign matter can reduce wiper effectiveness. Common sources are insects, tree sap, and hot wax treatments used by some commercial car washes.

If the blades are not wiping properly, clean the window and blades with a good cleaner or mild detergent; then rinse thoroughly with clean water. Repeat if necessary.

Washer Fluid

Inspecting Washer Fluid Level WARNING Use only windshield washer fl uid or plain water in the reservoir: Using radiator antifreeze as washer fl uid is dangerous. If sprayed on the ...

Replacing Windshield Wiper Blades

When the wipers no longer clean well, the blades are probably worn or cracked. Replace them. CAUTION To prevent damage to the wiper arms and other components, do not try to sweep ...

Other materials:

Direct Mode
Direct mode can be used for temporarily switching gears by operating the steering shift switch while the vehicle is being driven with the selector lever in the D range. While in direct mode, the D and M indication illuminate and the gear position in use is illuminated. Direct mode is can ...

Fuel Injector Inspection [Mzr 2.0, Mzr 2.5]
Resistance Inspection 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the fuel injector connector. 4. Inspect the resistance between fuel injector terminals A and B. Fuel injector resistance 11.4—12.6 ohms [20 °C {68 °F}] If not ...

How To Use This Manual
Range of Topics This manual contains procedures for performing all required service operations. The procedures are divided into the following five basic operations: Removal/Installation Disassembly/Assembly Replacement Inspection Adj ...