Mazda 3 Service Manual: Wipers

Washer Fluid Level Sensor Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the front bumper.. 3. Remove the washer tank.. 4. Remove the connector of the washer fluid-level sensor from the washer tank. 5. Remov ...

Rear Wiper Arm And Blade Adjustment

1. Turn off the rear wiper switch while operating the rear wiper motor, and then stop the rear wiper at the auto stop position. 2. Set the rear wiper arm onto the ceramic end line. ...

Other materials:

Fuel Tank Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring to ...

Automatic Transaxle Fluid (ATF) Adjustment [Fw6 A EL]
CAUTION: Only adjust the ATF level when the ATF temperature is 45—55 °C {113—131 °F}. If the ATF level is incorrect, it could damage the transaxle. Do not add ATF over the specification. Otherwise, the transaxle performance could be reduced and ATF could leak. 1. Remove a ...

Side Air Bag Sensor No. 1 Removal/Installation [Two Step Deployment Control System]
WARNING: Handling the side air bag sensor improperly can accidentally operate (deploy) the air bag module, which may seriously injure you. Read the air bag system service warnings and cautions before handling the side air bag sensor.. 1. Switch the ignition to off. 2. Disconnec ...