Mazda 3 Service Manual: Wipers, Washers

Power Seat Switch Inspection

1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the power seat switch connector. 4. Inspect for continuity between the power seat sw ...

Rear Wiper And Washer Switch Inspection

1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (Driver‘s side). b. Front side trim (Driver‘s side). c. Hood release lever. d. Lower panel. e ...

Other materials:

Brake Hose (Rear) Removal/Installation [Mzr 2.0, Skyactiv G 2.0]
CAUTION: If the brake hose is installed to the caliper on the vehicle, the tool cannot be installed correctly resulting in brake fluid leakage due to improper installation. Therefore, remove the caliper and brake hose as a single unit when removing the brake hose, and tighten the br ...

Ignition Switch Inspection [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the ignition switch.. 4. Verify that the continuity between the ignition switch terminals is as indicated in the table. If not as indicated in the table, replace the ignition switch. ...

Warranties for Your Mazda
New Vehicle Limited Warranty Powertrain Limited Warranty Safety Restraint System Limited Warranty Anti-perforation Limited Warranty Federal Emission Control Warranty/California Emission Control Warranty Emission Defect Warranty Emission Performance Warranty Emission Control ...