Mazda 3 manuals

Mazda 3 Service Manual: Air Cleaner Element Removal/Installation [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Intake / Air Cleaner Element Removal/Installation [Mzr 2.0, Mzr 2.5]

1. Set the air cleaner cover out of the way..

2. Remove the air cleaner element.

3. Install in the reverse order of removal.

Air Cleaner Element Inspection [Mzr 2.0, Mzr 2.5]
1. Remove the air cleaner element.. 2. Inspect the following items: Has the replacement interval come? Is the air cleaner element soiled, damaged, or bent? Are the air cleane ...

Air Filter Inspection
1. Verify that there is no damage, excessive dirt, or abnormal odor on the air filter. If there is any malfunction, replace the air filter. NOTE: The air filter cannot be reuse ...

Other materials:

Fuel Gauge
The fuel gauge shows approximately how much fuel is remaining in the tank when the ignition is switched ON. We recommend keeping the tank over 1/4 full. Type A/Type B instrument cluster Type C instrument cluster If the low fuel warning light illuminates or the fuel level is very low, ...

Parking in an Emergency
The hazard warning lights should always be used when you stop on or near a roadway in an emergency The hazard warning lights warn other drivers that your vehicle is a traffic hazard and that they must take extreme caution when near it. Depress the hazard warning flasher and all the t ...

Rear Turn Light Bulb Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Trunk mat. b. Trunk board. c. Trunk end trim. 3. Partially peel back the trunk side trim.. 4. Remove in the order indicated in the table. 1 Connector 2 ...

� 2016-2026 Copyright www.mazda3tech.com