Mazda 3 Service Manual
- Vehicle general
- Abbreviations
- Body And Accessories
- Body And Accessories SST
- How To Use This Manual
- Identification Number Locations
- Jacking Positions, Vehicle Lift (2 Supports) And Safety Stand (Rigid Rack) Positions
- Key Reminder Switch Inspection
- Key Reminder Switch Removal/Installation
- Power Systems Personalization Features Setting Procedure
- Pre Delivery Inspection
- Sae Standards
- Service Cautions
- Units
- Vehicle Identification Number (VIN) Code
- Accessories
- Body
- Doors/Lids & Hood/Trunk
- Body Exterior, Frame
- Glass & Windows
- Horn
- Driver Info & Control
- Body Interior
- Lighting & Horn
- Mirrors
- Roof - Fixed, Leisure
- Seats
- Wipers, Washers
- Brakes
- Drivetrain
- Electrical
- Engine
- General
- Belts, Hoses, Pulleys
- Control
- Cooling
- Emissions
- Engine Assembly
- Exhaust & Emissions
- Forced Induction
- Fuel
- Intake
- Lubrication
- HVAC
- Restraints
- Restraints SST [Standard Deployment Control System]
- Restraints SST [Two Step Deployment Control System]
- Adjuster Anchor Removal/Installation
- Air Bag Module And Pre Tensioner Seat Belt Deployment Procedures [Standard Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Deployment Procedures [Two Step Deployment Control System]
- Air Bag Module And Pre Tensioner Seat Belt Disposal Procedures
- Buckle Switch Inspection
- Child Restraint Seat Anchor Removal/Installation
- Front Buckle Removal/Installation
- Front Seat Belt Removal/Installation [Standard Deployment Control System]
- Front Seat Belt Removal/Installation [Two Step Deployment Control System]
- Rear Buckle Removal/Installation
- Rear Seat Belt Removal/Installation
- Seat Belt Inspection
- Steering
- General Procedures (Steering)
- Precaution
- Steering SST
- Steering Switch Inspection
- Steering Switch Removal/Installation
- Linkage, Power
- Wheel, Column
- Suspension
Personalization Features
The following personalization features can be set or changed by an Authorized
Mazda
Dealer. Consult an Authorized Mazda Dealer for details.
Additionally, some of the personalization features can ...
Vehicle general
...
Other materials:
Sunroof Motor Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the rain sensor cover. (Vehicles with auto light/wiper system).
3. Disconnect the rain sensor connector. (Vehicles with auto light/wiper system)
4. Partially peel back the seaming welts.
5. Remove the following parts:
a. Sunroof seaming ...
Interior Light Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the rain sensor cover. (Vehicles with auto light/wiper system).
3. Remove the following parts:
a. Sunroof seaming welt (vehicles with sunroof)
b. A-pillar trim.
c. Front scuff plate.
d. Rear scuff plate.
e. B-pillar lower trim.
f. ...
Installation Of Radio System
The control modules and control unit have been designed with sufficient attention
to radio wave disturbances from the outside. However, observe the following precautions
when installing the radio set to the vehicle to prevent adverse effects on the control
modules and control unit.
Inst ...
