Mazda 3 manuals

Mazda 3 Service Manual: Fuses & Junction Blocks

Mazda 3 Service Manual / Electrical / Fuses & Junction Blocks

Battery Removal/Installation [Skyactiv G 2.0]
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 1 Battery cover (See Battery Cover Removal Note.) (See Battery Cover In ...

Front Fog Light Relay Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the front mudguard.(RH). 3. Remove the front fog light relay case. 4. Remove the cover. 5. Remove the front fog light relay. 6. Insta ...

Other materials:

Front Seat Cover Removal/Installation [Vehicles Without Power Seat System]
WARNING: Handling a front seat (with built-in side air bag) improperly can accidentally operate (deploy) the air bag, which may seriously injure you. Read the service warnings before handling a front seat (with built-in side air bag).. CAUTION: After removing a front seat ...

Air Intake Actuator Removal/Installation [Manual Air Conditioner]
1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable.. 3. Remove the following parts: a. Front scuff plate (Passenger-side). b. Front side trim (Passenger-side). c. Dashboard under cover. d. Glove compartment. e. Lower panel (Passenger-side). f. Shower duct ( ...

Parking Brake Switch Inspection
1. Remove the upper panel.. 2. Disconnect the parking brake switch connector. 3. Verify that the continuity is as indicated in the table. If not as indicated in the table, replace the parking brake lever. ...

� 2016-2026 Copyright www.mazda3tech.com