Mazda 3 manuals

Mazda 3 Service Manual: Wheels, Tires

Rear Upper Arm Removal/Installation
1. When working on the right side of the vehicle, disconnect the canister vent (CV) solenoid valve from the rear crossmember. (MZR 2.0 (Except Mexico), SKYACTIV-G 2.0, MZR 2.3 DISI Turbo, MZR 2.5 ...

Malfunctioning Wheel Unit Identification
NOTE: The tire pressure monitoring system (TPMS) does not identify the location of the malfunctioning wheel unit on the vehicle (RF, LF, LR, RR). The TPMS identifies each wheel unit as N ...

Other materials:

Antenna Feeder No.1 Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate. b. Front side trim. c. Upper panel. d. Shift lever knob (MTX). e. Selector lever knob (ATX). f. Shift panel. g. Side wall. h. Console. i. Shift lever component (MTX). j. Selector lev ...

Brake Hose (Front) Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. Add brake fluid, bleed the brakes, and inspect for leakage after the installation has been completed.. 1 Brake pipe 2 Clip 3 ...

Direct Mode
Direct mode can be used for temporarily switching gears by operating the steering shift switch while the vehicle is being driven with the selector lever in the D range. While in direct mode, the D and M indication illuminate and the gear position in use is illuminated. Direct mode is can ...

� 2016-2026 Copyright www.mazda3tech.com