Mazda 3 manuals

Mazda 3 Service Manual: Driveline

Drivetrain
...

Driveline/Axle SST
49 F027 004 Attachment ø80 49 U027 005 Bearing installer 49 H027 002 Bearing remover 4 ...

Other materials:

Starter Inspection [Mzr 2.0, Mzr 2.5]
On-vehicle Inspection 1. Verify that the battery is fully charged. 2. The starter is normal if it rotates smoothly and without any noise when the engine is cranked. If the starter does not operate, inspect the following: Remove the starter, and inspect the starter unit. ...

Thermostat Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Variable Intake Air Shutter Valve Actuator Inspection [Mzr 2.0, Mzr 2.5]
Operation Inspection 1. Remove the air hose.. 2. Disconnect the vacuum hose from the variable intake air shutter valve actuator. 3. Connect a vacuum pump to the variable intake air shutter valve actuator. NOTE: Covered with a hood, the rod of the variable intake air shutter valv ...

� 2016-2026 Copyright www.mazda3tech.com