Mazda 3 manuals

Mazda 3 Service Manual: Drivetrain

Input/Turbine Speed Sensor Removal/Installation [FS5 A EL]
CAUTION: Always use a new bolt. If the removed input/turbine speed sensor installation bolt is reused, it may cause oil leakage. A sealant coating is applied to the input/turbine s ...

Driveline
...

Other materials:

Using Automatic Locking Mode
Follow these instructions when using a child-restraint system, unless you are attaching a LATCH-equipped childrestraint system to the rear LATCH lower anchors. Refer to “Using LATCH Lower Anchor” . NOTE Follow the child-restraint system manufacturer's instructions carefully. If you are ...

Starter Interlock Switch Inspection [Skyactiv G 2.0]
CAUTION: Do not reuse the starter interlock switch if it is removed from the vehicle even once. Replace with a new starter interlock switch when installing. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the starter interlock switch connec ...

Outer Mirror Glass Removal
1. Disconnect the negative battery cable. 2. Press area B of the mirror glass so that area A moves outward. 3. Detach pin B while lifting up the inside of the mirror glass holder. 4. Pull the mirror glass holder and remove pins A and C. 5. Disconnect the mirror heater connectors. (Ve ...

� 2016-2026 Copyright www.mazda3tech.com