Mazda 3 manuals

Mazda 3 Service Manual: Transmission/Transaxle

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle

Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]
CAUTION: If foreign materials are stuck to the sensor, disturbance by magnetic flux can cause sensor output to be abnormal and thereby negatively affect control. Make sure that foreign m ...

Information
...

Other materials:

Relay Block Inspection [With Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Driver-side front scuff plate. b. Driver-side front side trim. c. Hood release lever. d. Upper panel. e. Shift knob (MTX)(See MANUAL TRANSAXLE SHIFT MECHANISM REMOVAL/INSTALLATION [G66M-R].)(See MANUAL TRANSAX ...

Afs (Adaptive Front Lighting System) Off Switch Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the switch panel in the direction of the arrow shown in the figure. 3. Disconnect the connector. 4. Remove the AFS OFF switch in the direction of the arrow (2) shown in the figure while pressing the tabs in the direction of the arrow ...

Map Light Bulb Removal/Installation
1. Disconnect the negative battery cable.. 2. Insert a tape-wrapped fastener remover into the service hole and pry with the screwdriver in the direction shown by the arrow to remove the lens. 3. Remove the map light bulb. 4. Install in the reverse order of removal. ...

� 2016-2026 Copyright www.mazda3tech.com