Mazda 3 manuals

Mazda 3 Service Manual: Automatic Transmission Control

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic Transmission Control

Up Switch Inspection [Fw6 A EL]
Continuity Inspection NOTE: The up switch is built into the selector lever component. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the console. ...

Boost Air Temperature Sensor Inspection [Mzr 2.3 Disi Turbo]
Resistance Inspection NOTE: Because the boost air temperature sensor is integrated in the MAP sensor, replacing the boost air temperature sensor includes replacement of the MAP sensor/boos ...

Other materials:

Ignition Coil Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 1 Plug hole plate bracket 2 Connector ...

Radar Sensors (Rear)
The radar sensors (rear) for the rear vehicle monitoring system are equipped inside the rear bumper, one each on the left and right sides. Sedan Hatchback The surface area of the rear bumper near the radar sensors (rear) should always be clean so that the rear vehicle monitoring sys ...

Headlight Leveling Actuator Inspection
NOTE: Headlight leveling actuator are integrated with the front combination light. For the actuator inspection of the headlight auto leveling system, perform the headlight leveling actuator operation inspection.. 1. Measure the voltage at each terminal is as indicated in the ...

� 2016-2026 Copyright www.mazda3tech.com