Mazda 3 manuals

Mazda 3 Service Manual: Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic Transmission Control / Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]

CAUTION:

1. Perform the following procedures.

a. Remove the battery cover..

b. Disconnect the negative battery cable.

c. Remove the insulator from the transaxle.


2. Remove in the order indicated in the table.



1

Connector

2

VSS

3

O-ring


3. Install in the reverse order of removal.

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine ...

Manual transmission
...

Other materials:

Illuminated Entry System
When the illuminated entry system operates, the overhead light (switch is in the DOOR position) turn on for: About 30 seconds after the driver's door is unlocked and the ignition is switched off. About 15 seconds after all doors are closed and the ignition is switched off. About 5 se ...

Manual Transaxle Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover No.2 and the splash shield as a single unit.. 4. Drain the manual transaxle oil.. 5. Disconnect and/or remove the following parts in the engine compartment. a. Remove the batte ...

Vacuum Pump Inspection [Skyactiv G 2.0]
1. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump. 2. Install the vacuum gauge as shown in the figure, then check the vacuum. 3. Warn up the engine. If the pressure is less than the specification, inspect for the following. M ...

� 2016-2026 Copyright www.mazda3tech.com