Mazda 3 manuals

Mazda 3 Service Manual: Up Switch Inspection [Fw6 A EL]

Mazda 3 Service Manual / Drivetrain / Transmission/Transaxle / Automatic / Up Switch Inspection [Fw6 A EL]

Continuity Inspection

NOTE:

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the console..

4. Disconnect the selector lever component connector.


5. Verify that the continuity between selector lever component terminals B and H.


Up switch specification

Test condition

Continuity

Selector lever is in the M position (+) side position.

Continuity

Selector lever is not in the M position (+) side position.

No continuity


Up Switch Inspection [FS5 A EL]
1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the console.. d. Disconnect the selector lever component connector. ...

Automatic Transmission Control
...

Other materials:

Driving on Uneven Road
Your vehicle's suspension and underbody can be damaged if driven on rough/uneven roads or over speed bumps at excessive speeds. Use care and reduce speed when traveling on rough/uneven roads or over speed bumps. Use care not to damage the vehicle's underbody, bumpers or muffler(s) when dr ...

Engine Coolant Replacement [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Shroud Panel Removal/Installation
CAUTION: Because the shroud panel is installed to the bumper reinforcement, support the shroud panel using a jack before removing the bumper reinforcement so as not to apply excessive force to the shroud panel. Since the servicing is performed with the hood open, secure the hoo ...

� 2016-2026 Copyright www.mazda3tech.com