Mazda 3 manuals

Mazda 3 Service Manual: Engine Assembly

Mazda 3 Service Manual / Engine / Engine Assembly

Refrigerant Pressure Sensor Removal/Installation [Manual Air Conditioner]
1. Disconnect the negative battery cable.. 2. Discharge the refrigerant.. 3. Disconnect the refrigerant pressure sensor connector. CAUTION: If moisture or foreign material enters the ref ...

Crank, Balancer
...

Other materials:

Starter Interlock Switch Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Disconnect the starter interlock switch connector. 4. Remove the starter interlock switch from the pedal bracket. 5. Insert a new starter interlock switch into the pedal bracket hole in the direction indicated ...

Transaxle Oil Inspection [G35 M R]
1. Park the vehicle on level ground. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil level plug and washer. 4. Verify that the oil is near the brim of the plug port. If the oil level is lower than the low level, add the specified amount and type of oil through the ...

Electric Power Steering Oil Pump Component Disassembly/Assembly
CAUTION: The internal parts of the EHPAS control module and motor could be damaged if they receive an impact. Be careful when handling the EHPAS control module and motor to prevent the component from getting hit. Replace the electric power steering oil pump component if it has recei ...

� 2016-2026 Copyright www.mazda3tech.com