Mazda 3 manuals

Mazda 3 Service Manual: Brake Control, Vehicle Dynamics

Mazda 3 Service Manual / Brakes / Brake Control, Vehicle Dynamics

Vacuum Pump Removal/Installation [Skyactiv G 2.0]
1. Remove the plug hole plate.. 2. Remove the battery and battery tray.. 3. Pinch open the clamp using pliers and disconnect the vacuum hose from the vacuum pump. 4. Remove in the order sh ...

DSC HU/CM Inspection
1. Disconnect the DSC HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the DSC HU/CM wiring harness-side connector and inspect voltage, continuity, or resis ...

Other materials:

Power Window System Initialization Procedure
NOTE: If the following operations have been performed, initial setting is reset, and auto up/down and two-step down operation are disabled. Therefore, performing initial setting is necessary. Negative battery cable is disconnected. Power window main switch ...

Trunk Lid Opener Cable Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front seat (LH)(See FRONT SEAT REMOVAL/INSTALLATION.) b. Front scuff plate (LH). c. Rear scuff plate. d. B-pillar lower trim. e. Rear seat cushion. f. Rear seat back. g. Tire house trim (LH). h. Trunk end ...

Antenna Feeder No.7 Inspection
1. Disconnect the negative battery cable.. 2. Remove the liftgate upper trim.. 3. Disconnect the connector A and B.. 4. Verify that the continuity between antenna feeder No.7 terminals is as indicated in the table. If not as indicated in the table, replace antenna feeder No.7. ...

� 2016-2026 Copyright www.mazda3tech.com