Mazda 3 manuals

Mazda 3 Service Manual: Sensors, Switches, Relays

Rear ABS Wheel Speed Sensor Removal/Installation
1. Remove the under cover.. 2. Remove in the order indicated in the table. 3. Install in the reverse order of removal. 1 Connector 2 Bolt ...

ABS HU/CM Inspection
1. Disconnect the ABS HU/CM connector.. 2. Connect the negative battery cable.. 3. Attach the tester lead to the ABS HU/CM wiring harness-side connector and inspect the voltage, continuity, or r ...

Other materials:

Front passenger occupant classification system
The Subaru Solterra is equipped with an advanced front passenger occupant classification system that continuously monitors the status of the front passenger seat. Based on detected conditions, this intelligent system automatically activates or deactivates specific SRS airbags to optimize safet ...

Engine Disassembly/Assembly [Skyactiv G 2.0]
CAUTION: When the transaxle is installed, do not suspend the engine. Otherwise, the SST installation area of the cylinder head may be damaged due to excess weight. Only suspend the engine after separating the engine and transaxle. Applying excessive force (force of 100 N {10.2 ...

Automatic Transaxle Fluid (ATF) Inspection [Fw6 A EL]
CAUTION: If the ATF level is not within the specification or ATF is not adhering to the dipstick after warming up the engine, do not drive the vehicle. Otherwise, the transaxle could be damaged. ATF Level Inspection 1. Remove aerodynamic undercover No.2.. 2. Remove the dipstic ...

� 2016-2026 Copyright www.mazda3tech.com