Mazda 3 manuals

Mazda 3 Service Manual: Safety Systems

Accessory Socket Removal/Installation
Front 1. Disconnect the negative battery cable.. 2. Remove the upper panel.. 3. Remove the shift lever knob. (MTX). 4. Remove the selector lever knob. (ATX). 5. Remove the shift panel. 6. R ...

Active Command Modes Inspection [Blind Spot Monitoring (Bsm)]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “ ...

Other materials:

Unfastening the Seat Belt
Depress the button on the seat belt buckle. If the belt does not fully retract, pull it out and check for kinks or twists. Then make sure it remains untwisted as it retracts. NOTE If a belt does not fully retract, inspect it for kinks and twists. If it is still not retracting properly, ...

Condenser Inspection
1. Inspect the condenser for cracks, damage, and oil leakage. If there is any malfunction, replace the condenser. 2. Visually inspect the fins for clogging of foreign material. If any fins are clogged, remove the foreign material. 3. Visually inspect for bent fins. ...

Blower Motor Removal [Full Auto Air Conditioner]
NOTE: The blower motor is located on the A/C unit as shown in the figure. Perform the work from the front passenger side in the posture shown in the figure. 1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable. 3. Remove the following ...

� 2016-2026 Copyright www.mazda3tech.com