Mazda 3 manuals

Mazda 3 Service Manual: Blind Spot Monitoring (Bsm) Indicator Light Inspection

Mazda 3 Service Manual / Accessories / Safety Systems / Blind Spot Monitoring (Bsm) Indicator Light Inspection

NOTE:

1. Inspect the the outer mirror glass..

Blind Spot Monitoring (Bsm) Control Module Removal/Installation
CAUTION: If the BSM control modules are installed with the left and right modules reversed, a DTC will be displayed and system will enter the fail-safe function. Therefore, confirm that ...

Blind Spot Monitoring (Bsm) Indicator Light Removal/Installation
NOTE: The BSM indicator light is integrated with the outer mirror glass. 1. Remove the outer mirror glass.. ...

Other materials:

Back Up Light Switch Removal/Installation [A26 M R]
1. Disconnect the negative battery cable. 2. Disconnect the back-up light switch connector. 3. Remove the aerodynamic under cover No.2.. 4. Remove the back-up light switch with the gasket. 5. Install a new gasket and the back-up light switch to the transaxle case. Tightening torque ...

Wheel Hub Component Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Active Adaptive Shift (AAS)
Active Adaptive Shift (AAS) automatically controls the transaxle shift points to best suit the road conditions and driver input. This improves driving feel. The transaxle may switch to AAS mode when driving up and down slopes, cornering, driving at high elevations, or depressing the accelerat ...

� 2016-2026 Copyright www.mazda3tech.com