Mazda 3 Service Manual: Forced Induction

Exhaust System Removal/Installation [Mzr 2.0, Mzr 2.5]

WARNING: A hot engine and exhaust system can cause severe burns. Turn off the engine and wait until they are cool before removing the exhaust system. 1. Remove the battery cover.. 2 ...

Charge Air Cooler Inspection [Mzr 2.3 Disi Turbo]

1. Remove the charge air cooler cover.. 2. Remove the charge air cooler.. 3. Remove the air bypass valve.. 4. Plug ports A and B. 5. Verify that there is no air leakage when air is sent fr ...

Other materials:

Side Turn Light Inspection
Side turn light illumination inspection 1. Disconnect the negative battery cable.. 2. Remove the outer mirror glass.. 3. Remove the outer mirror garnish.. 4. Remove the side turn light.. 5. Connect the battery voltage as shown in the figure. If the side turn light does illuminat ...

A/C Unit Removal/Installation
1. Set the air mix mode to MAX COLD. 2. Disconnect the negative battery cable.. 3. Discharge the refrigerant.. 4. Drain the engine coolant.. 5. Remove the plug hole plate. 6. Remove the charge air cooler cover. (MZR 2.3 DISI Turbo). 7. Remove the insulator. (MZR 2.3 DISI Turbo) 8. ...

Ignition Switch Inspection [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Remove the ignition switch.. 4. Verify that the continuity between the ignition switch terminals is as indicated in the table. If not as indicated in the table, replace the ignition switch. ...