Mazda 3 manuals

Mazda 3 Service Manual: Control

Timing Chain Removal/Installation [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: If the camshaft is rotated with the timing chain removed ...

Information
...

Other materials:

Wheel Hub Component Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Antenna Feeder No.6 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Upper panel. b. Shift knob (MTX). c. Selector lever knob (ATX). d. Shift panel. e. Side wall. f. Console. g. Car-navigation unit. 3. Verify that the continuity between antenna feeder No.6 terminals is as i ...

Liftgate Removal/Installation
WARNING: When removing the stay damper, serious injury may occur if the stay damper is removed without supporting the liftgate. Always perform the procedure with at least another person. 1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Rear scuff p ...

� 2016-2026 Copyright www.mazda3tech.com