Mazda 3 Service Manual: Sensors, Switches, Relays
- Accelerator Pedal Position (App) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Air Fuel Ratio (A/F) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Air Fuel Ratio (A/F) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Camshaft Position (CMP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Camshaft Position (CMP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Crankshaft Position (CKP) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Crankshaft Position (CKP) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Engine Coolant Temperature (ECT) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
- Heated Oxygen Sensor (HO2 S) Inspection [Mzr 2.0, Mzr 2.5]
- Heated Oxygen Sensor (HO2 S) Removal/Installation [Mzr 2.0, Mzr 2.5]
- Intake Air Temperature (Iat) Sensor Inspection [Mzr 2.0, Mzr 2.5]
- Knock Sensor (Ks) Inspection [Mzr 2.0, Mzr 2.5]
- Knock Sensor (Ks) Removal/Installation [Mzr 2.0, Mzr 2.5]
- Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
- Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]
Voltage Inspection
NOTE:
The variable swirl shutter valve switch cannot be removed as a single unit.
When replacing the variable swirl shutter valve switch, replace it together
with the ...
Voltage Inspection
NOTE:
Because the APP sensor is integrated in the accelerator pedal, replacing
the APP sensor includes replacement of the accelerator pedal.
1. Connect the M-MDS t ...
Other materials:
Electric Vehicle system precautions
When operating or servicing the Subaru Solterra, it is essential
to remain aware of the presence of high-voltage components (nominal voltage approximately
355.2 V), including the traction battery, electricity supply unit, distinctive orange
high-voltage cables, and the electric motor. In addit ...
Antenna Feeder No.1 Removal/Installation
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Front scuff plate.
b. Front side trim.
c. Upper panel.
d. Shift lever knob (MTX).
e. Selector lever knob (ATX).
f. Shift panel.
g. Side wall.
h. Console.
i. Shift lever component (MTX).
j. Selector lev ...
Down Switch Inspection [Fw6 A EL]
Continuity Inspection
NOTE:
The down switch is built into the selector lever component.
1. Remove the battery cover..
2. Disconnect the negative battery cable..
3. Remove the console..
4. Disconnect the selector lever component connector.
5. Verify that the continuity betw ...