Mazda 3 manuals

Mazda 3 Service Manual: Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]

Mazda 3 Service Manual / Engine / Control / Sensors, Switches, Relays / Vehicle Speed Sensor (VSS) Removal/Installation [FS5 A EL]

CAUTION:

1. Perform the following procedures.

a. Remove the battery cover..

b. Disconnect the negative battery cable.

c. Remove the insulator from the transaxle.


2. Remove in the order indicated in the table.



1

Connector

2

VSS

3

O-ring


3. Install in the reverse order of removal.

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine ...

Cooling
...

Other materials:

Split/One-piece Folding the Seatback
By lowering the rear seatback(s) the luggage compartment space can be expanded. WARNING Do not drive the vehicle with occupants on folded down seatback(s) or in the luggage compartment. Putting occupants in the luggage compartment is dangerous because seat belts cannot be ...

Valve Clearance Inspection [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the wiring harness. 5. Remove the ignition coils.. 6. Remove the spark plugs.. 7. Remove the ventilation hose. 8. Remove the oil level gauge. 9. Remove the cylinder ...

Fuel Gauge Sender Unit Removal/Installation
MZR 2.0, MZR 2.5 NOTE: Fuel pump unit cannot be disassembled. 1. Remove the fuel gauge sender unit.. MZR 2.3 DISI Turbo NOTE: Fuel pump unit cannot be disassembled. 1. Remove the fuel gauge sender unit.. SKYACTIV-G 2.0 NOTE: Fuel pump unit cannot be disasse ...

� 2016-2026 Copyright www.mazda3tech.com