Mazda 3 manuals

Mazda 3 Service Manual: Power Sockets

No.2 Car Navigation System Does Not Operation [Car Navigation System]
2 Even if the map screen is touched, the car-navigation system cannot be operated Possible DTC — POSSIBLE CAUSE ...

Accessory Socket Inspection
Front 1. Disconnect the negative battery cable.. 2. Remove the upper panel.. 3. Remove the shift lever knob. (MTX). 4. Remove the selector lever knob. (ATX). 5. Remove the shift panel. 6. R ...

Other materials:

Aerodynamic Under Cover No.2 Removal/Installation
Except SKYACTIV-G 2.0 1. Lift up the vehicle. 2. Remove the fasteners and bolts. 3. Move the aerodynamic under cover No.2 in the direction of the arrow shown in the figure and remove it. CAUTION: Be careful not to damage the aerodynamic under cover No.2 during removal. 4. ...

Hood Latch And Release Lever Removal/Installation
Hood latch 1. Open the hood. 2. Disconnect the negative battery cable.. 3. Disconnect the hood latch switch connector. (vehicles with theft-deterrent system) 4. Remove the bolts. 5. Remove the hood latch. 6. Install in the reverse order of removal. 7. Adjust the hood.. Hood ...

Drive Belt Inspection [Mzr 2.0, Mzr 2.5]
MZR 2.0 A/C drive belt NOTE: Drive belt deflection/tension inspection is not necessary because of the use of the maintenance-free type A/C drive belt. Replace the drive belt if it is found to be damaged during visual inspection, or if there is a malfunction or noise in th ...

� 2016-2026 Copyright www.mazda3tech.com