Mazda 3 Service Manual: Lighting & Horn

Sunvisor Removal/Installation

1. Disconnect the negative battery cable.. 2. Remove the screw. 3. Rotate the sunvisor in the direction of the arrow. 4. Unhook and remove the sunvisor. 5. Disconnect the vanity mirror ill ...

General

...

Other materials:

Rear Door Trim Removal/Installation
1. Disconnect the negative battery cable.. 2. Move the hook in the direction of arrow shown in the figure using a tape-lapped flathead screwdriver and detach it from the rear door trim. CAUTION: Affix protective tape to the rear door trim and assist handle cover to prevent damag ...

Pilot Bearing Inspection [G35 M R]
1. Perform the following procedures. a. Remove the battery cover.. b. Disconnect the negative battery cable. c. Remove the battery component. (ex: battery, battery tray and PCM component). d. Remove the air cleaner component.. e. Remove the exhaust manifold insulator installation bolts an ...

On Board Diagnostic System PID/Data Monitor Inspection [Fw6 A EL]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “TCM”. 3. Select the applicable PID from the PID table. 4. Verify th ...