Mazda 3 manuals

Mazda 3 Service Manual: Belts, Hoses, Pulleys

Mazda 3 Service Manual / Engine / Belts, Hoses, Pulleys

Hydraulic Variable Valve Timing Actuator Inspection [Skyactiv G 2.0]
WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before servicing. CAUTION: Do not disassemble the hydraulic variable valve timing a ...

Drive Belt Auto Tensioner Inspection [Mzr 2.0, Mzr 2.5]
MZR 2.0 1. Remove the generator drive belt with the A/C drive belt still installed and set it out of the way.. 2. Verify that the drive belt auto tensioner moves smoothly in the operational dir ...

Other materials:

Manual Transaxle Removal/Installation [G66 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

Rear Brake (Disc) Removal/Installation
CAUTION: If the brake hose is installed to the caliper on the vehicle, the tool cannot be installed correctly resulting in brake fluid leakage due to improper installation. Therefore, remove the caliper and brake hose as a single unit when removing the caliper or brake hose, and tig ...

Splash Shield Removal/Installation
Front Splash Shield 1. Remove the bolts and fastener then remove the front splash shield. 2. Install in the reverse order of removal. Rear Splash Shield 1. Remove the fastener, screws and capnut . 2. Pull the rear splash shield in the direction of the arrow shown in the figure, the ...

� 2016-2026 Copyright www.mazda3tech.com