Mazda 3 Service Manual: Cruise Control

Accessories

...

Cruise Control Switch Inspection [Mzr 2.0, Mzr 2.5]

1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the driver–side air bag module.. 4. Disconnect the clock spring connector (part w ...

Other materials:

Rear Scuff Plate Removal/Installation
1. Detach tab A while pulling the rear scuff plate in the direction of the arrow (1) shown in the figure, then detach hook B, clips C, pins D while pulling in the direction of the arrow (2). 2. Detach tab E while pulling the rear scuff plate in the direction of the arrow (3) shown in the fig ...

Brake Fluid Level Sensor Inspection
1. Disconnect the brake fluid level sensor connector from the master cylinder. 2. Inspect for continuity according to fluid level between the brake fluid level sensor terminals. If not as indicated in the table, replace the reserve tank. ...

Front Stabilizer Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the joint cover.. 2. Disconnect the steering shaft from the steering gear and linkage.. 3. Remove the front crossmember component.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 6. Inspect the wheel alignment and adjust it if necessary ...