Mazda 3 manuals

Mazda 3 Service Manual: Glass & Windows

Mazda 3 Service Manual / Body / Glass & Windows

Theft Deterrent System Reading Freeze Frame Data
1. Connect the M-MDS (IDS) to the DLC–2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. Select “Body”. Select & ...

Base Installation
1. Cut away all of the original sealant using a razor. WARNING: Using a razor with bare hands can cause injury. Always wear gloves when using a razor. 2. Clean and degrease the cera ...

Other materials:

Blower Motor Removal [Full Auto Air Conditioner]
NOTE: The blower motor is located on the A/C unit as shown in the figure. Perform the work from the front passenger side in the posture shown in the figure. 1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable. 3. Remove the following ...

Manual Transaxle Removal/Installation [A26 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

DSC Sensor Initialization Procedure
WARNING: If the DSC sensor initialization procedure is not completed, the DSC will not operate properly and it might cause an unexpected accident. Therefore, after replacing or removing the DSC HU/CM or SAS control module, make sure to perform the DSC sensor initialization procedure ...

� 2016-2026 Copyright www.mazda3tech.com