Mazda 3 manuals

Mazda 3 Service Manual: Seats

Roof Molding Removal
1. Insert a fastener remover in the position shown in the figure. 2. Rotate the flathead screwdriver in the direction of the arrow (1) shown in the figure and remove the roof molding from the T-st ...

Active Headrest Inspection
1. Push the bottom of front seat back in the direction of arrow shown in the figure. 2. While inspecting for move the front seat back. ...

Other materials:

Spark Plug Inspection [Mzr 2.3 Disi Turbo]
Specification Spark plug type L3BD-18110, L3YD-18110 Plug Gap Inspection CAUTION: To avoid possible damage to the tip, do not adjust the plug gap. To prevent damaging the tip, use a wire type plug gap gauge when inspecting the plug gap. 1. Measure the spark p ...

Replacing a Tire
WARNING Always use tires that are in good condition: Driving with worn tires is dangerous. Reduced braking, steering, and traction could result in an accident. If a tire wears evenly, a wear indicator will appear as a solid band across the tread. Replace the tire when ...

Caliper (Rear) Disassembly/Assembly
1. Disassemble in the order indicated in the table. 1 Dust seal (See Dust Seal Assembly Note.) 2 Bleeder cap 3 Bleeder screw 4 Caliper body 2. Assemble in the reverse orde ...

� 2016-2026 Copyright www.mazda3tech.com