Mazda 3 manuals

Mazda 3 Service Manual: Active Headrest Inspection

Mazda 3 Service Manual / Body / Seats / Active Headrest Inspection

1. Push the bottom of front seat back in the direction of arrow shown in the figure.


2. While inspecting for move the front seat back.

Seats
...

Child Restraint Seat Anchor Removal/Installation
4SD 1. Remove the cover. 2. Remove the bolt and child-restraint seat anchor. 3. Install in the reverse order of removal. 5HB 1. Remove the trunk end trim.. 2. Remove the bolt and chi ...

Other materials:

DRL (Daytime Running Light) Bulb Removal/Installation
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo 1. Disconnect the negative battery cable.. 2. Disconnect the connector. 3. Rotate the DRL bulb in the direction of the arrow shown in the figure to remove it. 4. Remove the DRL bulb. 5. Install in the reverse order of removal. SKYACTIV-G 2.0 ...

Ignition Switch Removal/Installation [Without Advanced Keyless Entry And Push Button Start System]
1. Disconnect the negative battery cable.. 2. Remove the column cover.. 3. Detach the tab. 4. Pull the pin in the direction of the arrow shown in the figure and release the lock. 5. Disconnect the ignition switch connector and key interlock solenoid connector. 6. Remove the ...

Engine Tune Up [Mzr 2.3 Disi Turbo]
NOTE: If the accelerator pedal is depressed continuously for a specified time, the engine speed may decrease to the idle speed. This is due to the fuel cut control operation, which prevents overheating, and it does not indicate a malfunction. Engine Tune-up Preparation 1. Verify ...

� 2016-2026 Copyright www.mazda3tech.com