Mazda 3 manuals

Mazda 3 Service Manual: Power Seat Switch Inspection

Mazda 3 Service Manual / Body / Seats / Power Seat Switch Inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable and wait 1 min or more

..

3. Disconnect the power seat switch connector.

4. Inspect for continuity between the power seat switch connector terminals using an ohmmeter.


Slide Motor Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the slide motor connector. 4. Apply battery positive voltage to the slide motor term ...

Wipers, Washers
...

Other materials:

Pressure Sensor Removal/Installation [Two Step Deployment Control System]
1. Switch the ignition to off. 2. Disconnect the negative battery cable and wait for 1 min or more.. 3. Remove the inner garnish.. 4. Remove the front door trim.. 5. Remove the bolts. 6. Remove the pressure sensor. 7. Disconnect the connector from the pressure sensor by pressing the ...

Compression Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel ...

Manual Transaxle Removal/Installation [A26 M R]
CAUTION: Secure the steering wheel using tape or a cable to prevent the steering shaft from rotating after disconnecting the steering shaft. If the steering wheel rotates after the steering shaft and the steering gear and linkage are disconnected, the internal parts of the clock spr ...

� 2016-2026 Copyright www.mazda3tech.com