Mazda 3 manuals

Mazda 3 Service Manual: Slide Motor Inspection

Mazda 3 Service Manual / Body / Seats / Slide Motor Inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable and wait 1 min or more

..

3. Disconnect the slide motor connector.

4. Apply battery positive voltage to the slide motor terminals and inspect the slide motor operation



Motor operation

Connection

B+

GND

Forward

D

B

Backward

B

D


Seat Weight Sensor Removal/Installation [Two Step Deployment Control System]
CAUTION: When the seat weight sensor is replaced with a new one, perform the seat weight sensor calibration using the M–MDS.. When replacing the seat weight sensor, replace it ...

Power Seat Switch Inspection
1. Remove the battery cover.. 2. Disconnect the negative battery cable and wait 1 min or more.. 3. Disconnect the power seat switch connector. 4. Inspect for continuity between the power seat sw ...

Other materials:

Sirius Satellite Radio Antenna Feeder Removal/Installation
SIRIUS Satellite Radio Antenna Feeder No.1 NOTE: SIRIUS satellite radio antenna feeder No.1 is integrated with the dashboard wiring harness. 1. Refer to DASHBOARD DISASSEMBLY/ASSEMBLY. SIRIUS Satellite Radio Antenna Feeder No.2 NOTE: SIRIUS satellite radio antenna feeder ...

Water Pump Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Oil Pressure Switch Inspection
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before removing the exhaust system. 1. Disconnect the negative battery cable.. 2. Remove the aerodynamic under cover No.2.. 3. Remove the oil pressur ...

� 2016-2026 Copyright www.mazda3tech.com