Mazda 3 Service Manual: Blind Spot Monitoring (Bsm) Indicator Light Inspection
NOTE:
-
The BSM indicator light is integrated with the outer mirror glass.
1. Inspect the the outer mirror glass..
Storage
...
Blind Spot Monitoring (Bsm) Indicator Light Removal/Installation
NOTE:
The BSM indicator light is integrated with the outer mirror glass.
1. Remove the outer mirror glass.. ...
Other materials:
Rear Door Trim Removal/Installation
1. Disconnect the negative battery cable..
2. Move the hook in the direction of arrow shown in the figure using a tape-lapped
flathead screwdriver and detach it from the rear door trim.
CAUTION:
Affix protective tape to the rear door trim and assist handle cover to prevent
damag ...
Transaxle Range (TR) Switch Inspection [FS5 A EL]
CAUTION:
Water or foreign objects entering the connector can cause a poor connection
or corrosion. Be sure not to drop water or foreign objects on the connector
when disconnecting it.
Operation Inspection
1. Perform the following procedures to inspect the TR switch.
If t ...
Side Step Molding Installation
NOTE:
Double-sided adhesive tape has already been adhered to a new side step molding
for installation.
When a side step molding is to be reused, perform the following procedure:
1. Remove any grease or dirt from the affixing surface of the side step molding.
2. Affix double-si ...
