Mazda 3 manuals

Mazda 3 Service Manual: Magnetic Clutch Inspection [Manual Air Conditioner]

Mazda 3 Service Manual / HVAC / A/C / Magnetic Clutch Inspection [Manual Air Conditioner]

1. Connect battery to terminal A of magnetic clutch and ground to A/C compressor body.

SKYACTIV-G 2.0


MZR 2.0


MZR 2.5


2. Verify that the magnetic clutch operates.

Magnetic Clutch Inspection [Full Auto Air Conditioner]
1. Connect battery to terminal A of magnetic clutch and ground to A/C compressor body. SKYACTIV-G 2.0 MZR 2.3 DISI Turbo, MZR 2.5 2. Verify that the magnetic clutch operates. If ...

Passenger Compartment Temperature Sensor Inspection [Full Auto Air Conditioner]
1. Measure the temperature around the passenger compartment temperature sensor and measure the resistance between passenger compartment temperature sensor terminals B and D. If the cha ...

Other materials:

Compression Inspection [Mzr 2.3 Disi Turbo]
WARNING: Hot engines and oil can cause severe burns. Be careful not to burn yourself during removal/installation of each component. Fuel vapor is hazardous. It can very easily ignite, causing serious injury and damage. Always keep sparks and flames away from fuel. Fuel ...

Electrical System
Electrical Parts Battery cable Before disconnecting connectors or removing electrical parts, disconnect the negative battery cable. Wiring Harness To remove the wiring harness from the clip in the engine room, pry up the hook of the clip using a flathead screwdriver. ...

Fuel Filler Lid Opener Bezel Removal/Installation
1. Remove the screw. 2. Pull the fuel-filler lid opener bezel in the direction of the arrow (1) then remove the tab. 3. Move the fuel-filler lid opener bezel in the direction of the arrow (2) shown in the figure. 4. Remove the fuel-filler lid opener bezel. 5. Install in the rever ...

� 2016-2026 Copyright www.mazda3tech.com