Mazda 3 manuals

Mazda 3 Service Manual: HVAC SST


49 B061 014

Spring Lock Coupling Disconnect Tool


49 G061 001

Spring Lock Coupling Disconnect Tool


49 B061 015A

Holder


49 0839 425C

Bearing puller set


49 SE01 160

Valve seal pusher


49 D034 202

Support block



Airflow Mode Main Link Removal/Installation
1. Set the air intake mode to FRESH. 2. Set the air mix mode to MAX COLD. 3. Disconnect the negative battery cable.. 4. Remove the following parts: a. Front doors. b. Front scuff plate. c. ...

Heater Core Inspection
1. Inspect the heater core for damage, cracks, and water leakage. If there is any malfunction, replace the heater core. 2. Visually inspect the fins for bending. If there is any ...

Other materials:

Oil Pressure Switch Removal
MZR 2.0, MZR 2.5, MZR 2.3 DISI Turbo WARNING: A hot engine can cause severe burns. Turn off the engine and wait until it is cool before removing the exhaust system. 1. Disconnect the negative battery cable. 2. Remove the aerodynamic under cover No.2.. 3. Disconnect the connecto ...

Rear Door Quarter Glass Removal/Installation
1. Fully lower the rear door glass. 2. Disconnect the negative battery cable.. 3. Remove the rear door trim.. 4. Remove the service hole cover. 5. Remove the hole plug. 6. Remove the screw. 7. Remove the bolt A and B. 8. Remove the rear door glass guide. 9. Remove the pin ...

Drive Belt Inspection [Skyactiv G 2.0]
Generator Drive Belt NOTE: The generator drive belt deflection/tension inspection is not necessary with the adoption of the drive belt auto tensioner. 1. Verify that the indicator part of the cast hexagon on the drive belt auto tensioner is within the normal range. If ...

� 2016-2026 Copyright www.mazda3tech.com