Mazda 3 manuals

Mazda 3 Service Manual: Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

Mazda 3 Service Manual / Electrical / Ignition / Ignition Coil/Ion Sensor Removal/Installation [Skyactiv G 2.0]

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the plug hole plate..

4. Remove the plug hole plate bracket..

5. Remove in the order indicated in the table.

6. Install in the reverse order of removal.



1

Connector

2

Ignition coil


Ignition Coil Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the charge air cooler.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of rem ...

Ignition Key Illumination Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the column cover upper.. 3. Remove the ignition key illumination bulb. 4. Install in the reverse order of removal. ...

Other materials:

Variable Valve Timing Actuator Inspection [Mzr 2.0, Mzr 2.5]
CAUTION: Variable valve timing actuator can not be disassembled because it is a precision unit. 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the plug hole plate.. 4. Disconnect the wiring harness. 5. Remove the ignition coils.. 6. Remo ...

Rear Window Glass Installation
WARNING: Using a utility knife with bare hands can cause injury. Always wear gloves when using a utility knife. CAUTION: Proper installation of the glass may be difficult if sealant is cracked or the glass is pushed out by air pressure when a door is opened/closed with al ...

Rear Door Checker Removal/Installation
1. Fully close the rear door glass. 2. Disconnect the negative battery cable.. 3. Remove the rear door trim.. 4. Remove the rear door speaker.. 5. Remove the bolt A. 6. Remove the bolts B. 7. Pull out the rear door checker from the rear door speaker installation hole. 8. Insta ...

� 2016-2026 Copyright www.mazda3tech.com