Mazda 3 manuals

Mazda 3 Owners Manual: Plastic Part Maintenance

Aluminum Wheel Maintenance
A protective coating is provided over the aluminum wheels. Special care is needed to protect this coating. CAUTION Do not use any detergent other than mild detergent. Before using any ...

Interior Care
WARNING Do not spray water in the cabin: Splashing water on electrical parts such as the audio unit and switches is dangerous as it could cause a malfunction or a fi re. ...

Other materials:

Blower Motor Removal [Full Auto Air Conditioner]
NOTE: The blower motor is located on the A/C unit as shown in the figure. Perform the work from the front passenger side in the posture shown in the figure. 1. Set the air intake mode to FRESH. 2. Disconnect the negative battery cable. 3. Remove the following ...

Engine Coolant Temperature (ECT) Sensor Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: When the engine is hot, it can badly burn. Turn off the engine and wait until it is cool before removing the ECT sensor. ECT Sensor No.1 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Drain the engine coolant.. 4. Remove the battery and b ...

Vehicle Speed Sensor (VSS) Inspection [FS5 A EL]
On-Vehicle Inspection 1. Inspect the power supply circuit for the VSS. a. Remove the insulator from the transaxle. b. Disconnect the VSS connector. c. Switch the ignition to ON (engine off). d. Measure the voltage at VSS connector terminal A (harness-side). If there is a ...

� 2016-2026 Copyright www.mazda3tech.com