Mazda 3 Owners Manual: Maintenance and Care
How to keep your Mazda in top condition.
- Essential Information
- Scheduled Maintenance
- Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)
- Scheduled Maintenance (Mexico)
- Maintenance Monitor
- Owner Maintenance
- Owner Maintenance Precautions
- Hood
- Engine Oil
- Engine Coolant
- Brake/Clutch Fluid
- Washer Fluid
- Wiper Blades
- Battery
- Battery Replacement
- Tires
- Light Bulbs
- Fuses
- Appearance Care
Storage Compartments
WARNING
Keep storage boxes closed when
driving:
Driving with the storage boxes open is
dangerous. To reduce the possibility of
injury in an accident or a sudden stop,
keep the ...
Essential Information
Be extremely careful and prevent injury to yourself and others or damage to
your vehicle
when using this manual for inspection and maintenance.
If you are unsure about any procedure it describes ...
Other materials:
Wheel Hub Component Inspection
Wheel Bearing Excessive Play Inspection
1. Remove the brake caliper component and disc plate..
2. Install the magnetic base and dial gauge as shown in the figure and measure
the wheel bearing axial excessive play.
If it exceeds the maximum specification, replace the wheel hub compon ...
Back Up Light Switch Removal/Installation [A26 M R]
1. Disconnect the negative battery cable.
2. Disconnect the back-up light switch connector.
3. Remove the aerodynamic under cover No.2..
4. Remove the back-up light switch with the gasket.
5. Install a new gasket and the back-up light switch to the transaxle case.
Tightening torque ...
Electro Hydraulic Power Assist Steering (EHPAS) Control Module Configuration
CAUTION:
If the EHPAS CM configuration is not completed, the EHPAS will not operate
properly. If the EHPAS CM is replaced, always carry out the EHPAS CM configuration
so that the EHPAS operates properly.
1. Connect the M-MDS (IDS) to the DLC-2.
2. After the vehicle is ident ...
