Schedule 2
Maintenance Monitor (Type A audio)Hazard Warning Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the center panel..
3. Verify that the continuity between the hazard switch terminals is as indicated
in the table.
If not as indicated in the table, replace the hazard warning switch.
4. Apply battery voltage to hazar ...
Check Valve Inspection [Skyactiv G 2.0]
Airflow Inspection
1. Remove the vacuum hose..
2. Blow air into the vacuum hose using your mouth from the vacuum pump side and
verify that the air flows to the intake manifold side, then blow air from the intake
manifold side and verify that the air does not flow to the vacuum pump side.
...
Rear Tilt Motor Inspection
1. Remove the battery cover..
2. Disconnect the negative battery cable and wait 1 min or more..
3. Disconnect the rear tilt motor connector.
4. Apply battery positive voltage to the rear tilt motor terminals and inspect
the rear tilt motor operation
If not as specified, replace t ...