Mazda 3 manuals

Mazda 3 Owners Manual: Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)

Mazda 3 Owners Manual / Maintenance and Care / Scheduled Maintenance / Scheduled Maintenance (U.S.A., Canada, and Puerto Rico)

Follow Schedule 1 if the vehicle is operated mainly where none of the following conditions (severe driving conditions)apply.

If any do apply, follow Schedule 2. (Puerto Rico residents follow Schedule 2.) Vehicles using Engine Oil Flexible Maintenance Engine Oil Flexible Maintenance is available for U.S.A. and Puerto Rico residents whose vehicle is operated mainly where none of the following conditions apply:

If any do apply, follow Schedule 2 with engine oil fixed maintenance.

Once engine oil flexible maintenance is selected, the vehicle calculates the remaining oil life based on engine operating conditions. The vehicle lets you know when an oil change is due by illuminating the wrench indicator light in the instrument cluster. Change the oil as soon as possible within the next 500 km (300 mile) or 15 days. Refer for the details.

Mazda Genuine 0W-20 Oil and Castrol ® 0W-20 Oil are required to achieve optimum performance.

NOTE

Scheduled Maintenance
...

Schedule 1
U.S.A. residents - Engine oil flexible maintenance interval Use when the maintenance monitor for “Oil Change” is set to “Flexible”. For details, see maintenance monitor. Chart symbols ...

Other materials:

Seat Belt Extender
If your seat belt is not long enough, even when fully extended, a seat belt extender may be available to you at no charge from your Authorized Mazda Dealer. This extender will be only for you and for the particular vehicle and seat. Even if it plugs into other seat belts, it may not hold in ...

Center Cover Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the center panel.. 3. Remove the upper clumn cover.. 4. Remove the instrument cluster.. 5. Pull the center cover in the direction of arrow (1) shown in the figure, then remove the hooks. 6. Pull the center cover in the direction of ...

Antenna Feeder No.5 Inspection
1. Disconnect the negative battery cable.. 2. Remove the following parts: a. Front scuff plate (RH). b. Front side trim (RH). c. Rear seat cushion. d. Rear scuff plate (RH). e. Tire house trim (RH). 3. Disconnect the antenna feeder No.4. 4. Disconnect the antenna feeder No.3. ...

� 2016-2026 Copyright www.mazda3tech.com