AUTO switch
By pressing the AUTO switch the following functions will be automatically controlled in accordance with the selected set temperature:
NOTE AUTO switch indicator light
OFF switch
Pressing the OFF switch shuts off the climate control system.
Temperature control dial
This dial controls temperature. Turn it clockwise for hot and counterclockwise for cold.
NOTE
Fan control switch
The fan has seven speeds. The selected speed will be displayed.
Mode selector switch
The desired airflow mode can be selected .
NOTE
A/C switch
Pressing the A/C switch while the AUTO switch is turned on will turn off the air conditioning (cooling/dehumidifying functions).
The air conditioning can be turned on and off by pressing the A/C switch while the fan control switch is on.
NOTE
Air intake selector
Outside or recirculated air positions can be selected. Press the switch to select outside/ recirculated air positions.
Recirculated air position ( )
Outside air is shut off. Use this position when going through tunnels, driving in congested traffic (high engine exhaust areas) or when quick cooling is desired.
Outside air position ( )
Outside air is allowed to enter the cabin. Use this mode for ventilation or windshield defrosting.
WARNING
Do not use the ![]() in cold or rainy weather: Using the ![]() or rainy weather is dangerous as it will cause the windows to fog up. Your vision will be hampered, which could lead to a serious accident. |
DUAL switch
Use the DUAL switch to change the mode between the individual operation (driver and passenger) and interconnection (simultaneous) modes.
Individual operation mode (indicator light illuminated)
The set temperature can be controlled individually for the driver and front passenger.
Interconnection mode (indicator light turned off)
The set temperature for the driver and front passenger is controlled simultaneously.
Windshield defroster switch
Press the switch to defrost the windshield and front door windows.
Map Light Bulb Removal/Installation
1. Disconnect the negative battery cable..
2. Insert a tape-wrapped fastener remover into the service hole and pry with
the screwdriver in the direction shown by the arrow to remove the lens.
3. Remove the map light bulb.
4. Install in the reverse order of removal. ...
Windshield Defrosting and
Defogging
Set the mode selector dial to the
position.
Set the temperature control dial to the
desired position.
Set the fan control dial to the desired
speed.
If dehumidified heating is desired, turn
on the air conditioner.
WARNING
Do not defog the windshield using the
pos ...
Liftgate Latch Switch Inspection
1. Disconnect the negative battery cable..
2. Remove the following parts:
a. Liftgate upper trim.
b. Liftgate side trim.
c. Liftgate lower trim.
d. Liftgate latch and lock actuator.
3. Press the latch in using a flathead screwdriver to inspect the latch lever
condition.
4. Verify ...