Mazda 3 Service Manual: Ignition Coil Removal/Installation [Mzr 2.0, Mzr 2.5]

Ignition Coil Inspection [Mzr 2.0, Mzr 2.5]

Ignition Coil Inspection 1. Perform the spark test and identify the malfunctioning cylinder.. 2. Replace the ignition coil of the malfunctioning cylinder with that of a normal cylinder, and perfo ...

Ignition Coil Removal/Installation [Mzr 2.3 Disi Turbo]

1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the charge air cooler.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of rem ...

Other materials:

Neutral Switch Removal/Installation [A26 M R]
1. Disconnect the negative battery cable. 2. Disconnect the neutral switch connector. 3. Remove the aerodynamic under cover No.2.. 4. Remove the neutral switch with the gasket. 5. Install a new gasket and the neutral switch to the transaxle case. Tightening torque 29—39 N·m ...

Engine Coolant Leakage Inspection [Mzr 2.0, Mzr 2.5]
WARNING: Never remove the cooling system cap or loosen the radiator drain plug while the engine is running, or when the engine and radiator are hot. Scalding engine coolant and steam may shoot out and cause serious injury. It may also damage the engine and cooling system. Tu ...

Evaporator Temperature Sensor Inspection [Manual Air Conditioner]
NOTE: Inspect the evaporator temperature sensor when it is installed to the A/C unit. 1. Set the fan speed MAX HI. 2. Set the temperature control at MAX COLD. 3. Set the RECIRCULATE mode. 4. Turn the A/C switch off. 5. Close all doors and windows. 6. Wait for 5 min. 7. D ...