Mazda 3 Service Manual: Ignition

Starter Cut Relay Removal/Installation [MTX]

Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable.. 2. Remove the following parts: Front scuff plate (LH). Front side trim (LH). ...

Forced Ignition On [With Advanced Keyless Entry And Push Button Start System]

NOTE: In order to perform a forced ignition ON, the M-MDS (IDS) is necessary. If the servicing is being done outside of an Authorized Mazda dealership, contact an Authorized Mazda dealer ...

Other materials:

Gear Shift Indicator
The gear shift indicator supports you to obtain optimum fuel economy and smooth driving. It displays the selected gear position in the instrument cluster as well as notifies the driver to change to the most suitable gear position corresponding to the actual driving condition. CAUTI ...

If You Must Use the Front Seat for Children
If you cannot put all children in the rear seat, at least put the smallest children in the rear and be sure the largest child up front uses the shoulder belt over the shoulder. NEVER put a rear-facing child-restraint system on the front passenger seat whether your vehicle is equipped with a ...

Engine Oil Level Inspection [Mzr 2.0, Mzr 2.5]
1. Position the vehicle on level ground. 2. Warm up the engine. 3. Stop the engine and allow at least 5 min before continuing. 4. Remove the dipstick, wipe it cleanly, and reinstall it fully. 5. Remove the dipstick and verify that the oil level is between the F and L marks on the dipstick. ...