Mazda 3 manuals

Mazda 3 Service Manual: Starter Cut Relay Removal/Installation [MTX]

Mazda 3 Service Manual / Electrical / Fuses & Junction Blocks / Starter Cut Relay Removal/Installation [MTX]

Advanced Keyless Entry And Push Button Start System Only

1. Disconnect the negative battery cable..

2. Remove the following parts:

3. Set the hood release lever out of the way..

4. Remove the lower panel..

5. Disconnect the connector.


6. Remove the nut.


7. Remove the starter cut relay.

8. Install in the reverse order of removal.

Starter Cut Relay Inspection [MTX]
Advanced Keyless Entry And Push Button Start System Only 1. Disconnect the negative battery cable. 2. Remove the following parts: a. Front scuff plate (LH). b. Front side trim (LH). c. Side w ...

Ignition
...

Other materials:

Audio Operation Using Voice Recognition (Type B)
Main audio operation The below commands are examples of the available commands. When the talk button is pressed and the following command is spoken out, the audio can be operated. The commands in the () can be omitted. The specified name and number are put into the {}. NOTE Some c ...

Forward Sensing Camera (FSC)
Your vehicle is equipped with a Forward Sensing Camera (FSC). The Forward Sensing Camera (FSC) is positioned near the rearview mirror and used by the following systems. High Beam Control System (HBC) Lane Departure Warning System (LDWS) The Forward Sensing Camera (FSC) determines t ...

Disc Pad (Front) Replacement [Mzr 2.0, Skyactiv G 2.0, Mzr 2.5]
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 3. After installation, pump the brake pedal a few times and verify that the brakes do not drag. 1 Clip 2 Retaining clip (See FRONT BRAKE (DISC ...

� 2016-2026 Copyright www.mazda3tech.com