Mazda 3 manuals

Mazda 3 Service Manual: Spark Plug Removal/Installation [Mzr 2.3 Disi Turbo]

Mazda 3 Service Manual / Electrical / Ignition / Spark Plug Removal/Installation [Mzr 2.3 Disi Turbo]

CAUTION:

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the charge air cooler..

4. Remove the ignition coils..

5. Remove the spark plugs using a plug-wrench.

6. Install in the reverse order of removal.

Spark Plug Removal/Installation [Mzr 2.0, Mzr 2.5]
CAUTION: If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing. 1. Remove the battery co ...

Spark Plug Removal/Installation [Skyactiv G 2.0]
CAUTION: If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing. 1. Remove the battery co ...

Other materials:

Battery Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove in the order indicated in the table. 2. Install in the reverse order of removal. 1 Battery cover (See Battery Cover Removal Note.) (See Battery Cover Installation Note.) 2 Negative battery cable 3 ...

Active Command Modes Inspection [Instrument Cluster]
1. Connect the M-MDS (IDS) to the DLC-2. 2. After the vehicle is identified, select the following items from the initialization screen of the IDS. a. Select “DataLogger”. b. Select “Modules”. c. Select “IC”. 3. Select the simulation items from the PID table. 4. Perform ...

Map Light Removal/Installation
1. Disconnect the negative battery cable.. 2. Remove the tabs shown in the figure. 3. Pull the map light in the direction of the arrow (1) shown in the figure and remove the map light while detaching the clips. 4. Disconnect the connector. 5. Install in the reverse order of removal ...

� 2016-2026 Copyright www.mazda3tech.com