Mazda 3 manuals

Mazda 3 Service Manual: Spark Plug Removal/Installation [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Electrical / Ignition / Spark Plug Removal/Installation [Mzr 2.0, Mzr 2.5]

CAUTION:

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the plug hole plate..

4. Remove the ignition coils..

5. Remove the spark plugs using a plug-wrench.

6. Install in the reverse order of removal.

Spark Plug Inspection [Skyactiv G 2.0]
Specification Spark plug type PE01-18110, PE02-18110, PE5R-18110, PE5S-18110 Plug Gap Inspection CAUTION: To avoid possible damage to the tip, do not adjust the plug gap. ...

Spark Plug Removal/Installation [Mzr 2.3 Disi Turbo]
CAUTION: If a spark plug that is not as specified is installed, engine performance will be deteriorated. Install only the specified spark plug when replacing. 1. Remove the battery co ...

Other materials:

Back Up Light Switch Removal/Installation [C66 M R]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the aerodynamic under cover No.2.. 4. Remove in the order indicated in the table. 5. Install in the reverse order of removal. 1 Back-up light switch connector 2 ...

Positive Crankcase Ventilation (PCV) Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove the intake manifold and the fuel distributor component as a single unit.. 4. Remove in the order indicated in the table. 1 Oil separator 2 Retainer ...

Filament Inspection
1. Turn the ignition switch to the ON position. 2. Turn the rear window defroster switch on. CAUTION: Directly touching the rear window defroster filament with the lead of the tester could damage it. Wrap aluminum foil around the end of the lead and inspect the filament by touc ...

� 2016-2026 Copyright www.mazda3tech.com