Mazda 3 manuals

Mazda 3 Owners Manual: Modification and Add-On Equipment

Mazda 3 Owners Manual / Before Driving / Security System / Modification and Add-On Equipment

Mazda cannot guarantee the immobilizer and the theft-deterrent systems' operation if the system has been modified or if any add-on equipment has been installed.

CAUTION To avoid damage to the vehicle, do not modify the system or install any add-on equipment to the immobilizer and the theft-deterrent systems or the vehicle.
Security System
...

Immobilizer System
The immobilizer system allows the engine to start only with a key the system recognizes. If someone attempts to start the engine with an unrecognized key, the engine will not start, thereby hel ...

Other materials:

Rear Bumper Removal/Installation
4SD 1. Disconnect the negative battery cable.. 2. Remove the rear combination light.. 3. Remove the fastener A and screw B. 4. Remove the rear splash shield.. 5. Remove the screws C. 6. Remove the bolts D. 7. Affix the protective tape to the position shown in the figure. ...

Base Removal
1. Remove the rearview mirror.. 2. Wind each end of a wire around a bar. WARNING: Using the piano wire with bare hands can cause injury. Always wear gloves when using the piano wire. NOTE: Use a long sawing action to spread the work over the whole length of the pi ...

Drive Belt Removal/Installation [Mzr 2.3 Disi Turbo]
1. Remove the aerodynamic under cover No.2 and splash shield as a single unit.. 2. Rotate the drive belt auto tensioner in the direction shown in the figure and remove the drive belt. 3. Install the drive belt. 4. Verify that the drive belt auto tensioner indicator mark does not exceed ...

� 2016-2026 Copyright www.mazda3tech.com