Mazda 3 Service Manual: Auto Dimming Mirror Installation

Auto Dimming Mirror Inspection

1. Measure the voltage at each terminal. If the voltage is not as specified in the Terminal Voltage Table (Reference), inspect the parts under “Inspection item (s)” and related wiring h ...

Auto Dimming Mirror Removal

1. Disconnect the negative battery cable. 2. Remove the screw. 3. Disconnect the auto-dimming mirror connector. 4. Pull out the rearview mirror toward the vehicle rear. CAUTION: ...

Other materials:

Barometric Pressure (Baro) Sensor Inspection [Mzr 2.0, Mzr 2.5]
Voltage Inspection NOTE: Because the BARO sensor is integrated in the PCM, replacing the BARO sensor includes replacement of the PCM. 1. Connect the M-MDS to the DLC–2. 2. Switch the ignition to ON. 3. Verify that the BARO sensor output voltage (PID: BARO) is within the s ...

Headlight Aiming
CAUTION: If the headlight aiming is adjusted with cargo in the vehicle, it may not adjust correctly. Adjust the headlight aiming with the vehicle under the following conditions: No occupants inside vehicle Cargo other than spare tire, jack, and tools not loaded ...

Customer Assistance (U.S.A.)
Your complete and permanent satisfaction is our business. We are here to serve you. All Authorized Mazda Dealers have the knowledge and the tools to keep your Mazda vehicle in top condition. If you have any questions or recommendations for improvement regarding the service of your Mazda ...