Mazda 3 manuals

Mazda 3 Service Manual: Canister Vent (Cv) Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Mazda 3 Service Manual / Engine / Emissions / Canister Vent (Cv) Solenoid Valve Inspection [Mzr 2.0, Mzr 2.5]

Except for Mexico

Airflow inspection

1. Remove the battery cover..

2. Disconnect the negative battery cable..

3. Remove the CV solenoid valve..

4. Inspect airflow between the ports under the following conditions.



Measured condition

Continuity between A—B

When voltage is not applied between terminals A and B

Airflow detected

When voltage is applied between terminals A and B

No airflow


Emissions
...

Canister Vent (Cv) Solenoid Valve Removal/Installation [Mzr 2.0, Mzr 2.5]
Except for Mexico 1. Remove the battery cover.. 2. Disconnect the negative battery cable.. 3. Remove in the order indicated in the table. 1 CV solenoid valve connect ...

Other materials:

Fuel Tank Removal/Installation [Mzr 2.0, Mzr 2.5]
WARNING: Fuel is very flammable liquid. If fuel spills or leaks from the pressurized fuel system, it will cause serious injury or death and facility breakage. Fuel can also irritate skin and eyes. To prevent this, always complete the “Fuel Line Safety Procedure”, while referring ...

After Service Precaution [Mzr 2.0, Mzr 2.5]
WARNING: Fuel line spills and leakage are dangerous. Fuel can ignite and cause serious injuries or death and damage. When installing the fuel hose, perform “Fuel Leakage Inspection” described below. A person charged with static electricity could cause a fire or explosion, ...

Filament Repair
1. Clean the filament using isopropyl alcohol. 2. Attach tape to both sides of the filament. 3. Using a small brush or marking pen, apply silver paint. 4. After 2—3 min, carefully remove the tape without damaging the applied area. CAUTION: Do not operate the rear window defro ...

� 2016-2026 Copyright www.mazda3tech.com