Mazda 3 manuals

Mazda 3 Service Manual: Glass Panel Removal/Installation

Mazda 3 Service Manual / Body / Roof - Fixed, Leisure / Glass Panel Removal/Installation

1. Fully close the glass panel.

2. Fully open the sunshade.

3. Remove the screws, and then remove the glass panel.


4. Peel the weatherstrip off the glass panel.


5. Install in the reverse order of removal.

6. Adjust the glass panel..

Glass Panel Adjustment
1. Fully close the glass panel. 2. Measure the gap and height between the glass panel and body. If not as specified, loosen the glass panel installation screws and reposition the glas ...

Rear Drain Hose Installation
CAUTION: If the rear drain hose is pinched or bent anywhere, the water in the hose may not discharge and enter the inside of the vehicle. During and after installation of the trims and t ...

Other materials:

Wheel Hub Component Removal/Installation
CAUTION: Performing the following procedures without first removing the ABS wheel-speed sensor may possibly cause an open circuit in the wiring harness if it is pulled by mistake. Before performing the following procedures, disconnect the ABS wheel-speed sensor connector (axle side) ...

Engine Oil Level Inspection [Mzr 2.0, Mzr 2.5]
1. Position the vehicle on level ground. 2. Warm up the engine. 3. Stop the engine and allow at least 5 min before continuing. 4. Remove the dipstick, wipe it cleanly, and reinstall it fully. 5. Remove the dipstick and verify that the oil level is between the F and L marks on the dipstick. ...

Air Bleeding
CAUTION: If the strainer is removed, impurities may penetrate the power steering system and damage it. To prevent this, always bleed air with the strainer installed. Do not maintain the steering wheel fully turned for 5 s or more. The oil temperature could rise and damage ...

� 2016-2026 Copyright www.mazda3tech.com