Mazda 3 Owners Manual: Mute
The microphone can be muted during a call.
- Press the talk button with a short press.
- Say: [Beep] “Mute”
- Prompt: “Microphone muted”
Canceling mute
- Press the talk button with a short press.
- Say: [Beep] “Mute off”
- Prompt: “Microphone unmuted”
Transferring a Call from Hands- Free to a Device (Mobile Phone)
Communication between the hands-free unit and a device (Mobile phone) is canceled, and the line can be switched to a standard call using a device (Mobile phone).
- Press the talk button with a short press.
- Say: [Beep] “Transfer call”
- Prompt: “Transferred call to phone”
Transferring a Call from a Device (Mobile Phone) to Hands-Free
Communication between devices (Mobile phone) can be switched to Bluetooth ® Hands-Free.
- Press the talk button with a short press.
- Say: [Beep] “Transfer call”
- Prompt: “Transferred call to Hands Free system”
Making a Call
Phonebook Usage
Telephone calls can be made by saying
the name of a person (voice tag) whose
phone number has been registered in
Bluetooth ® Hands-Free in advance. Refer
to Phonebook registratio ...
Call interrupt
A call can be interrupted to receive an
incoming call from a third party.
Switch to a new incoming call using the
following methods.
Method 1
Press the pick-up button.
Prompt: “Swapping ...
Other materials:
Body Control Module (Bcm) Inspection
1. Remove the following parts:
a. Front scuff plate (LH).
b. Front side trim (LH).
c. Upper panel.
d. Shift knob (MTX).
e. Selector lever knob (ATX).
f. Shift panel.
g. Side wall.
h. Console.
2. Set the hood release lever out of the way..
3. Remove the lower panel. (driver-side). ...
Turn and Lane-Change Signals
The ignition must be switched ON to use
the turn and lane-change signals.
Turn Signals
Move the signal lever down (for a left
turn) or up (for a right turn) to the stop
position. The signal will self-cancel after
the turn is completed.
If the indicator light continues to flash
after a turn ...
Rain Sensor Removal/Installation
1. Disconnect the negative battery cable..
2. Spread open the rain sensor cover in the direction of the arrows and disengage
tabs A to remove it.
3. Disconnect the rain sensor connector.
4. Slide rain sensor tab B in the direction of the arrow shown in the figure
and detach tab B. ...
